Taiwan touch tripod Chang, screen protect the ink 
 (PET, ITO for the protection of gum) 
 The TP-06 touch screen to protect the plastic operating instructions: 
 This protection of plastic for a special one-component touchscreen acid, insulation protection products, mainly used in the insulation of the touch screen, acid, moisture and protection. PET, ITO film and ITO glass by screen printing, play a love to pollution or scratch effects to prevent the above materials in the production process. Before the bonding of the next line on the touch screen, simple method available torn off, the protection of plastic will be left in the surface or contaminated materials. This product can be embodied in a wide range of temperature and humidity within the insulation protection film forming excellent with good toughness and softness. 

 First, the product features: 
 1, solvent resistance and acid and alkali resistance to etching (20%) had no effect 

 2, water resistance (soaked 20-50 ° C water 12 hours had no effect) 

 Insulation:> 1011Ω 

 Resistance, grilled limit (200 ° C, 2.5 hours) 

 5, good flexibility, smooth and shining no residue, easy to strip; 

 6, easy screen printing quit net non-stick plates, easy to operate cost-effectively protect the ITO film or ITO glass in order to improve the production yield 

 7, the color blue (LB) fineness ≤ 5um (2.0MTL) 

 Viscosity: 300 ~ 550dps (25 ° C, the VT-04 viscometer) 

 9, solid content: 80% 

 Second, the recommended conditions of use (process) 
 1, printing mesh: (78 ~ 100T) 200 ~ 250mesh 

 2 spacious site or the printing of the full version recommended 78T polyester mesh. 

 Emulsion thickness: 20 ~ 30um 

 4, polyester plastic scraper 75 ~ 80 °, adjust the blade angle and printing speed. 

 5, in order to achieve adequate coating thickness, the best is only printed once, so the network mode to completely fill the ink and then printing. 

 6, is expected to open by the ITO film or ITO glass screen printing on the back to protect the ink to protect plastic TP-06, infrared tunnel furnace 130 ~ 150 ° C × 5 minutes, vertical furnace 130 ~ 150 ℃ × 10 minutes. 

 ITO film / ITO conductive glass surface screen printing the TP-08 protect inks, infrared tunnel furnace 130 ~ 150 ° C × 5 minutes, a vertical furnace of 130 ~ 150 ° C × 8 ~ 10 minutes. 

 8, the UV curing (600-1000mj / c ㎡): in the ITO film on ITO glass with (1500-1800mj / c ㎡) peel is best. Another oven drying is also applicable 

 9, such as exposing intolerance in general, to protect the glue is not completely dry; 

 Common problems and solutions: 

 A, the ink film flake peel resistance to tear 
 Printing too thin, the temperature is too low, the lack of time. 
 Solve: ○ coarse mesh, thicker network model, representing a soft scraper. ○ 2 control temperature or appropriate to raise the temperature and time. 
 B, the edge of the ink film with glue 
 Resolved: ○ 1 printing is too thin. ○ 2 temperature is too low, the lack of time. 
 C, the edge of the ink film serrated or dog teeth 
 To solve: 02 1 Check printing lines to avoid improper use of thinner flat ○ 
 D, the ink film can not be stripped 
 To solve: 02 1 oven temperature is too high. ○ long drying time.